雙組份打膠機在使用中會(huì )出現怎樣的問題?
雙組份打膠機的使用效率高且效果好,但是使用時間長了或者其他原因導致的,問題時有發生,下面小編講解四個常見的問題。
The two-component sealant dispenser is efficient and effective, but problems often occur due to a long time of use or other reasons. Here are four common problems.
1.膠水流體內產生氣泡:在全自動打膠機使用期間,過大的流體壓力再外部打開點膠閥時,可能將空氣滲入膠水中,從而產生了氣泡。
1. Bubbles are generated in the glue fluid: during the use of the full-automatic glue dispenser, when the dispensing valve is opened externally under excessive fluid pressure, air may seep into the glue, resulting in bubbles.
2.自動打膠機使用時出現漏膠:點膠閥在使用完畢后正常關閉,出現膠水滲漏,這是因為配置的針頭太小,影響液體的流動造成背壓。
2. Glue leakage occurs when the automatic glue dispenser is used: the glue dispensing valve is normally closed after use, and glue leakage occurs, because the configured needle is too small, affecting the flow of liquid and causing back pressure.
3.全自動打膠機流速太慢:膠水流速若太慢主要是膠管過窄或者過長,當然還要注意出膠口和氣壓是不是處于正常情況。
3. The flow rate of the full-automatic glue dispenser is too slow: if the glue flow rate is too slow, it is mainly because the rubber hose is too narrow or too long. Of course, pay attention to whether the glue outlet and air pressure are normal.
4.平臺打膠機設備出膠量大小不一致:出膠量大小不一致的情況主要是儲存膠水流體的壓力筒還有機器配置空氣壓力不穩定所產生。
4. The glue output of the platform glue dispenser is inconsistent: the inconsistent glue output is mainly caused by the unstable pressure of the pressure cylinder for storing glue fluid and the air pressure configured for the machine.
雙組份打膠機在使用中會(huì )出現怎樣的問題?講了四個問題,實際上還有很多類型的問題需要提前進行預防。關注我們
http://m.xxcyqzj.com了解更多!
What problems will occur in the use of two-component glue dispenser? Four problems have been mentioned. In fact, there are many types of problems that need to be prevented in advance. Follow us http://m.xxcyqzj.com Learn more!
上一篇:打膠機組成部分的五點保養事項
下一篇:雙組份打膠機的日常使用注意事項